Notices de montage pour un full hood et un half hood

Tout ce qui concerne les questions techniques et la mécanique sur les châssis, les éléments de carrosserie, l'habitacle, et la cosmétique seven

Modérateur : Modérateurs

Avatar de l’utilisateur
Daf
Sevener bienfaiteur
Messages : 396
Inscription : 27 juin 2015, 18:44
Localisation : [BEL]
Seven : 275 S

Notices de montage pour un full hood et un half hood

Message par Daf »

Sans rentrer dans le débat des avantages du full hood ou du half hood, voici les notices de montage.

Nombreux sont ceux qui ont difficile à monter un full hood. Cependant, avec un tout petit peu d'entrainement, 3 à 5 minutes suffisent. Il faut évidemment que les sangles qui retiennent les barres (hood sticks) soient bien installées (longueur adéquate).
Voici la notice de montage (testée et éprouvée).
Quick guide hood.jpg
Et voici pour l'installation du half hood Caterham (ou Thundersport). Le montage du half hood Soft Bits est très légèrement différent.

1. Take the 2 Long Straps and remove the clip end from the strap as shown in figure 1. You may need to undo the bolts on the rear of the roll bar on some series 5 cars to get the gap big enough.
Fig1.jpg
2. Feed the Velcro end of the straps through the gap between you roll bar bracket and bodywork as shown in figure 2.
Fig2.jpg
3. The plastic buckle at the end of the strap will stop it coming all the way through and will hold it in place.
4. Re-attached the clip end to the strap.
5. Undo the bulkhead bolts using a 13mm spanner and place the short strap eyelet over the hole and replace the bolt, figure 3.
Fig3.jpg
6. Your straps are now fitted and you can popper the half hood onto your windscreen.
7. Lay the hood onto your roll bar and clip the 4 straps to it.
8. Tighten the side straps first then the rear straps and you are complete.
Vous ne pouvez pas consulter les pièces jointes insérées à ce message.
Répondre